Combi Boiler probs

[Retlaw]

On the front of the boiler next to the timer for setting the central heating is a small dial marked in bars, 1 2 3 then goes into red, on some boilers if the neddle is below 1 bar the boiler refuses to ignite, if below 1 bar you need to refill to at least 1 1/2 bar, then see what happens the instruction manual should show you where the refill tap is.

Retlaw

[mez]

i had a new combi-boiler fitted some 3 years ago with h/h its an halstead (rubbish pure rubbish) they don't fit them anymore.....i ring the repairs dept at least every 6 weeks to complain that i get cold water when the heating isnt on ......its been "oh its the pressure i'll adjust it " quite a few times anyway the last time i rang about 5 weeks ago they sent a "clever s*d " round he did nothing only drew me a circuit of water pipes & stated that cos of the length of pipe it will take longer..............now ive kept my peace but am now coming up to a storm again h/homes watch out im onto nearly 10mins before i get hot water,grrrrrrrr.

[derekgas]

Originally Posted by mez

i had a new combi-boiler fitted some 3 years ago with h/h its an halstead (rubbish pure rubbish) they don't fit them anymore.....i ring the repairs dept at least every 6 weeks to complain that i get cold water when the heating isnt on ......its been "oh its the pressure i'll adjust it " quite a few times anyway the last time i rang about 5 weeks ago they sent a "clever s*d " round he did nothing only drew me a circuit of water pipes & stated that cos of the length of pipe it will take longer..............now ive kept my peace but am now coming up to a storm again h/homes watch out im onto nearly 10mins before i get hot water,grrrrrrrr.

If it takes 10 minutes to get hot water, there is no way that is down to the length of the pipe run! Even if you lived in a huge mansion, with the boiler at one end and the sink at the other, it would not take 10 minutes to get hot water, it is a boiler fault mez, you are right about the boiler being rubbish, whoever designed the system with such a long pipe run is as much at fault.

[mez]

it was never a problem with my old boiler that hey replaced.........& its still the same pipework.


think im pe*ing them off a bit......

[derekgas]

Originally Posted by Retlaw

On the front of the boiler next to the timer for setting the central heating is a small dial marked in bars, 1 2 3 then goes into red, on some boilers if the neddle is below 1 bar the boiler refuses to ignite, if below 1 bar you need to refill to at least 1 1/2 bar, then see what happens the instruction manual should show you where the refill tap is.

Retlaw

Stanley mad has said that the heating works and the hot water is intermittent, so it does ignite and is nothing to do with the pressure, also, I am reasonably confident that even the council engineers would have the nounce to check the pressure!

[Neil]

Originally Posted by derekgas

That is because hardly any other boiler is as reliable as the back boilers, very simple operation with few components, the downside is that they are also one of the least efficient.

They may cost more money in gas but will not cost as much in maintenance over say a 20 or 30 year life span. Come to think think of it I bet no modern condensing combi will last 30 years.

If you are talking efficiency in money terms (which for me is the important bit) you need to work out the cost on install, maintenace, repairs and the gas.

I will keep my back boiler for now thanks with its 5 main components.

[BERNADETTE]

Originally Posted by Neil

They may cost more money in gas but will not cost as much in maintenance over say a 20 or 30 year life span. Come to think think of it I bet no modern condensing combi will last 30 years.

If you are talking efficiency in money terms (which for me is the important bit) you need to work out the cost on install, maintenace, repairs and the gas.

I will keep my back boiler for now thanks with its 5 main components.

I would rather have a back boiler as well but to late they installed a new system

[Stanleymad]

UPDATE:

Well just had HH up & thankfully the boiler was being its usual pain in the butt, unlike before with the same plumber, so least it got treated a bit more seriously this time & bit more investigation, nice evil boiler stayed evil hahaha. He thinks that the hot water switch is overheating & cutting out to the cold water [????? if that makes sence Derek lol] so as Margaret rightfully says it is still in warrenty even just over 12mths so HH cant take off the inner panel as breaks warrenty, so i have to wait till tommorow for an Alpha engineer to come up to sort it but in the mean time have to put up with 1 min it works & another it dont as plumber found out too.

[Ber999T]

Well Stanleymad have they been able to get your boiler sorted today?

Nothing worse than not having hot water when you need it

[Stanleymad]

Originally Posted by Ber999T

Well Stanleymad have they been able to get your boiler sorted today?

Nothing worse than not having hot water when you need it

Not yet, nowt worse than waiting in for people lol, it worked a bit this morning & having just checked again to attempt to wash up its not fired up, so hoping its not sods law & will still be unfiring till engineer gets here, whats betting it'll play nice when he's here

[Stanleymad]

Boiler man here & by turning on tap & looking knows whats up with it - so thats good, hopefully will have hot water on tap soon Cheers for all of your help & concern its been fantastic thanks